Chapter ring

Discussion in 'General Freemasonry Discussion' started by zouzoum, Aug 11, 2014.

  1. zouzoum

    zouzoum Registered User

    89
    6
    8
    Wearing ur chapter ring instead of FM ring ? Do u see it better in a place where the fraternity is not

    Sent From My Freemasonry Pro App
     
  2. Companion Joe

    Companion Joe Premium Member

    858
    899
    113
    I don't have a Chapter ring, but I have been looking for a nice one. I don't know that I see anything in a better place than the other (and I'm not real sure what you are asking). I'd wear a Chapter ring to YR events and my S&C ring to Blue Lodge events. That's what I do with lapel pins.
     
  3. zouzoum

    zouzoum Registered User

    89
    6
    8
    I mean that wearing s&c ring in some areas where ppl r against the fraternity would be noticed so masons avoid to wear it. So I mean can u replace ur everyday ring with ur royal arch ring bcz most ppl wouldnt knw it

    Sent From My Freemasonry Pro App
     
  4. MarkR

    MarkR Premium Member

    1,002
    819
    133
    Most days I wear a S&C ring. Some days I wear my 14° Scottish Rite ring; almost nobody outside of the craft would know what it is.
     
  5. Brother JC

    Brother JC Vigilant Staff Member

    3,202
    2,029
    183
    A triple Tau could evoke a lot of emotion, depending on the person. If I do advertise Chapter, I wear a keystone watch fob, which is common, but not as recognizable as the S&C. I'd like to get a pin like the piece in my avatar.
    If wearing the S&C is a problem, you might just forgo any rings or pins. Or wear a "flip" ring.
     
  6. Companion Joe

    Companion Joe Premium Member

    858
    899
    113
    I don't wear my ring daily because I am not a jewelry guy. About the only time I wear it is to lodge, church, funeral home, dress up events, etc. I don't take into consideration what someone might think. I am proud to be a Mason. If they'd like to think crazy things, I am more than happy to discuss it with them and set them straight (or at least as much as they are willing to be straighten out).
     
    Warrior1256 and Morris like this.
  7. Warrior1256

    Warrior1256 Site Benefactor

    7,332
    3,328
    183
    Same here. I was made an MM last Monday and right after the ritual I put on my S & C ring and have not taken it off since. If someone sees my ring and dosen't like it, too bad. I'm very proud and honored to be a member of the Craft and will always wear my ring.
     
  8. crono782

    crono782 Premium Member

    1,598
    380
    103
    Being HP and TIM this year, I want to get a chapter and/or council ring. Haven't seen any I like yet though.


    Sent From My Freemasonry Pro App
     
  9. El Dud3rino

    El Dud3rino Registered User

    64
    6
    8
    Go check Etsy, they have some neat ones there. I found 00 (7/16) plugs there with the S&C. But they have some nice hand made stuff.



    Brother Joel
    Master Mason
    Epes Randolph Lodge #32
    Tucson AZ
     

Share My Freemasonry